Nokia MetroSite EDGE Installation Manual page 37

Fixing the pole brackets and the mounting rack onto a pole
Note
Before taking the mounting rack to the pole, perform the tasks instructed in Steps
1 and 2 below.
1.
2.
3.
4.
5.
6.
DN991456 © Nokia Corporation
Issue 3 en Nokia Proprietary and Confidential
All manuals and user guides at all-guides.com
To fix the upper pole bracket to the mounting rack, screw the M6 x 20
Allen screws through holes R1 and R2 into the upper front block, as shown
in Figure 10. Make sure that the front block is the correct way up (the set
of three adjacent screw holes on the back of the block should be on the
upper edge). Use a torque driver with a 4 mm Allen bit to tighten the screws
to 5.5 Nm (4.06 lb ft).
To fix the lower pole bracket to the mounting rack, screw the M6 x 20
Allen screws through holes R5 and R6 into the lower front block, as shown
in Figure 10. Make sure that the three adjacent screw holes are on the upper
edge of the block. Use a torque driver with a 4 mm Allen bit to tighten the
screws to 5.5 Nm (4.06 lb ft).
Bring the mounting rack/pole bracket combination to the pole.
Position the upper front block of the pole bracket on the pole. Rotate the
back block so that you can insert the free bolt and square nut into the free
slot on the other side of the front block.
Tighten the bolts in even stages to fix the upper pole bracket to the pole.
Use a torque socket spanner/wrench with a 6 mm Allen bit to tighten the
bolts to 12 Nm (8.85 lb ft).
Fix the lower bracket to the pole in the same manner as the upper bracket.
Mounting the BTS
37 (72)