Pole Mounting; Table 7. Parts And Pole Diameters Required For Pole Installation - Nokia MetroSite EDGE Installation Manual

Table of Contents

Advertisement

Fixing the BTS to the mounting rack
1.
2.
3.
4.
5.
6.2

Pole mounting

Pole mounting includes three work phases:
1.
2.
3.
Table 7.
Part
Mounting rack
Pole mounting kit, containing:
34 (72)
© Nokia Corporation
Nokia Proprietary and Confidential
All manuals and user guides at all-guides.com
Hang the BTS on the upper fixing screws, B1 and B2 in Figure 7. Do not
tighten them yet!
Position the two offset screws which are attached to the L-beam (on the
back of the cabinet) into the offset screw slots on the lower part of the
mounting rack, as shown in the inset illustration in Figure 7.
Tighten the upper BTS fixing screws (B1 and B2 in Figure 7) using a
torque driver and a 4 mm Allen bit with a shaft of at least 60 mm in length.
Tighten the screws to 5.5 Nm (4.06 lb ft).
Tighten the offset screws on the L-beam to 12 Nm (8.85 lb ft) using a
torque socket spanner/wrench and a 6 mm Allen bit with an 80 mm
extension. See the inset illustration in Figure 7, which shows the rear view
of the cabinet.
If you have removed any of the units, proceed to Chapter 7. If you have not
removed any units, proceed directly to Chapter 8.
Pre-assembling the pole brackets.
Installing the pole brackets and the mounting rack on the pole.
Fixing the BTS to the mounting rack.
Parts and pole diameters required for pole installation
Small-pole kit: 2 front blocks, 2 back blocks, 4
bolts, 4 square nuts, 4 washers, 4 Allen screws
Large-pole kit: 2 front blocks, 2 metal bands, 2
locking devices, 4 Allen screws
Installation
Notes
Provided in the BTS
transportation package
For poles of diameter:
Small poles: 60 - 120 mm
(2.4 - 4.7 in)
Large poles: 120 - 300 mm
(4.7 - 11.8 in)
DN991456
Issue 3 en

Advertisement

Table of Contents
loading

Table of Contents