Care And Cleaning - Fujitsu ASTG18KMCB Operating Manual

Care and Cleaning

• Before cleaning this product, be sure to turn it off and disconnect all the power supply.
• Before starting operation, make sure that the intake grille has been shut completely. Incomplete closing of the intake grille might have an
effect on the proper working or performance of the air conditioner.
• Do not touch the aluminum fi ns of heat exchanger built-in the indoor unit to avoid personal injury when you maintain the unit.
• Do not expose the indoor unit to liquid insecticides or hair sprays.
• Do not stand on slippery, uneven or unstable surfaces when you maintain the unit.
Daily care
When cleaning the indoor unit body, mind the following:
• Do not use water hotter than 40 °C.
• Do not use scouring cleanser, volatile solvents such as benzene or
thinner.
• Wipe the unit gently by using soft cloth.
Cleaning the intake grille
Open the intake grille in direction of the arrow a. While gently
1
pressing the left and right mounting shafts of the intake grille
outward b, remove the intake grille in direction of the arrow c.
c
b
a
Wash the intake grille gently with water or wipe it gently with a
2
soft cloth moisten with warm water.
Then wipe it with a dry and soft cloth.
While holding the grille horizontal, set the left and right mounting
3
shafts into the pillow blocks at the top of the panel a. To latch
each shaft properly, insert the shaft until it snaps.
Then close the intake grille b.
a
b
4 Press 4 places on the intake grille to close it completely.
OPERATING MANUAL
En-10
CAUTION
c
b
a
a
b
Cleaning the air fi lters
Mind that you have a periodical cleaning of the air fi lters to prevent
reducing the operation effi ciency of the product.
Using of clogged air fi lter with dust will lower the product performance,
and may cause airfl ow reduction or increase of operating noise.
Clean the air fi lters once every 2 weeks under normal use.
Open the intake grille.
1
(Refer to a of step 1 in "Cleaning the intake grille".)
While holding the intake grille with your hand, pull up the handle
2
a of the fi lter in direction of the arrow and release the 2 claws b.
Then pull the fi lter out with gently sliding it downward c.
a
b
Filter holder and air cleaning fi lter are attached on the rear side
3
of the air fi lter. Remove them from the air fi lter by unlatching each
corner of the fi lter holder d.
d
d
Remove dust by using a vacuum cleaner or by washing the fi lter.
4
When you wash the fi lter, use neutral household detergent and
warm water.
After rinse the fi lter well, dry it thoroughly in a shaded place
before you reinstall it.
Attach the air cleaning fi lter and the fi lter holder to each air fi lter.
5
Attach the air fi lter with aligning both side of the fi lter with the front
6
panel, and push in the fi lter fully.
NOTES:
Make sure that 2 claws are fi rmly snapped to the guide holes on
the panel.
Close the intake grille fi rmly.
7
(Refer to step 4 in "Cleaning the intake grille".)
c
a
b
d
d
(continued)