Esco 10964 Calibration Procedure

Digital wall mounted tire inflator

Calibration Procedure –

Model #10964

NOTE: Make sure the inflation unit is disconnected from the power supply before

starting Step 1.

Step 1: Connect the inflator Inlet to a >100 PSI air source.

Step 2:

Press and hold the Target pressure control buttons ("+" and "–") on the faceplate of the

10964 Inflator.

Step 3:

Turn on the inflator and when the LCD display shows "06A" code release control

buttons ("+" and "–")

Step 4:

Press the "i/SET" unit option button until the "CAL" code is shown on the inflator's LCD

display.

15270 Flight Path Drive Brooksville, FL 34604

DIGITAL WALL MOUNTED TIRE INFLATOR

ESCO – Equipment Supply Company

Website:

www.esco.net

Phone: 800-352-9852

●

Email: info@esco.net

●

Fax: 352-754-4508

Table of Contents

Need help?

Do you have a question about the 10964 and is the answer not in the manual?

Page 1 (“+” and “–“) Step 4: Press the “i/SET” unit option button until the “CAL” code is shown on the inflator’s LCD display. ESCO – Equipment Supply Company 15270 Flight Path Drive Brooksville, FL 34604 Phone: 800-352-9852 Fax: 352-754-4508 ●...
Page 2 The display screen will show a reading of “100 PSI”, at this point shut off the air source and calibration is complete. ESCO – Equipment Supply Company 15270 Flight Path Drive Brooksville, FL 34604 Phone: 800-352-9852 Fax: 352-754-4508 ●...