Clarke CDS2 Leaflet

Drill stand

DRILL STAND

Model No. CDS2

Thank you for purchasing this CLARKE Drill Stand

Please read this leaflet to ensure the Stand is assembled correctly in

order that it will provide you with long and satisfacyory service.

GUARANTEE

This product is guaranteed against faulty manufacture for a period of 12

months from the date of purchase. Please keep your receipt as proof of

purchase.

This guarantee is invalid if the product is found to have been abused or

tampered with in any way, or not used for the purpose for which it was

intended.

Faulty goods should be returned to their place of purchase, no product

can be returned without prior permission.

This guarantee does not effect your statutory rights.

Table of Contents

Do you have a question about the CDS2 and is the answer not in the manual?

Page 1 DRILL STAND Model No. CDS2 Thank you for purchasing this CLARKE Drill Stand Please read this leaflet to ensure the Stand is assembled correctly in order that it will provide you with long and satisfacyory service. GUARANTEE This product is guaranteed against faulty manufacture for a period of 12 months from the date of purchase.
Page 2 ASSEMBLY Insert the Column into the base and secure with the two screws using a hex wrench (not supplied) Slide the head on to the column and secure to the column at any convenient position. IMPORTANT! Secure the base to a workbench or sturdy table using M8 bolts (not supplied).
Page 3 Finally, tighten the securing bolts. Parts and Service Contacts For Spare Parts and Service, please contact your nearest dealer, or CLARKE International, on one of the following numbers. PARTS & SERVICE TEL: 020 8988 7400 PARTS & SERVICE FAX: 020 8558 3622 e-mail as follows: PARTS: Parts@clarkeinternational.com...