Table of Contents
Advertisement
13. Setting Sensitivity Parameters
You may encounter the following problems during counting/sorting:
Machine doesn't sort the notes properly
■
Machine frequently recognizes good notes as unfit notes
■
Please contact your technician/dealer to have the machine's sensitivity parameters adjusted.
In case of a technical problem that can't be solved by the operator, please contact your supplier.
Maintenance
1. Cleaning the Device
For optimal performance the machine needs to be cleaned regularly. Clean the hopper and stacker
with the enclosed brush.
2. Cleaning the Banknote Transport System
Open the upper back panel.
2
Gently wipe the banknote pathway with a small, soft brush or a dry, soft, lint-free cloth.
3
If dirt remains, slightly moisten a soft cotton cloth with distilled water or a 50/50 distilled
water/isopropyl alcohol solution and wipe the banknote pathway and the senor surfaces again. Do
not let any liquid drip into the device.
4
Repeat steps 1 ~3 to clean the banknote pathway of the lower drawer.
II
II
Replacing the fuse
WARNING: To avoid risk of electric shock, always disconnect the main power cable before
removing the fuse holder.
Fuse holder
8
Note: To protect against malfunction, replace onl y with same t y pe and resistance fuses.
Adjusting feeder's aperture
The adjusting screw of the feeder aperture on the top cover has already
been set at the factory. You may need to adjust the feeder aperture if the
following problems occur during counting/sorting:
■ Frequent jams or banknotes pass the feeder with difficulty: Turn the
adjusting screw clockwise to make the aperture wider.
■ Frequent "double notes" or "chained notes" error message: Turn the
adjusting screw counter-clockwise to make the aperture smaller.
To test it, place a banknote between the wheels in the hopper to imitate banknote feeding and keep
hold of it. If you feel the pull on the banknote when wheels are turning, the machine is workable.
8
Note: The adjusting screw is ver y sensitive. Move onl y one notch at a time!
If the machine doesn't turn on, it may be
caused by a burnt fuse. Open the fuse cover
holder and replace the fuse.
P1D
Advertisement
Table of Contents
