Touch NAME EDIT.
The NAME EDIT screen appears.
Current name display
Name input display
Name input buttons
Enter the name.
After the name has been entered, touch SET. The new
function name is set in the commander.
After the name has been entered, point the
commander toward the receiver and touch UPLOAD.
The new function name is set in the receiver.
Setting remote control codes that are not
stored in the commander
When a remote control code is not one of the presets
stored in the commander, it is possible for the commander
to learn the code using the Learning function. For details
on how to use the learned codes, please see page 17.
name to the
The SETUP screen appears.
Touch to set
the name to
Touch the area corresponding to where you want
the new code to be learned. Any letter from A to J
can be selected (for example, select "A").
Touch the Box Number where you want to save the
new code (for example, select "A6").
The LEARNING SETUP screen is displayed.
Box number assigned for new code
Touch "Learning Start".
"Please Send Signal" is displayed.
Code set mark
assigned for new