Husqvarna K 7000 Operator's Manual page 23

1. Connect the water hose to the water supply. Refer to
Technical data on page 28 for the lowest permitted
water flow.
Note:
The hose nipple of the product has a filter.
2. Push the power trigger lockout to open the water
valve.
3. Adjust the water flow with your thumb during the
operation.
To dry cut
CAUTION:
cutting are recommended only for
intermittent operation.
CAUTION:
around the cutting blade to decrease the
temperature.
1635 - 003 - 20.08.2021
Diamond blades for dry
Always use sufficient airflow
1. Turn the button 180˚ to adjust the direction of the
water.
2. Push the knob to stop the flow of water.
The water goes through the return hose.
To start the product
1. Hold the rear handle with your right hand.
2. Push the power trigger lockout and hold in the power
trigger.
3. Let the product operate with no load for 30 seconds.
To stop the product
WARNING:
continues to rotate for a while after the
motor stops. Make sure that the cutting
blade can rotate freely until it fully stops. If it
is necessary to stop the cutting blade
quickly, let the cutting blade lightly touch a
hard surface. Risk of serious injury.
The cutting blade
23