Safety - Husqvarna DM400 Operator's Manual

Compliance reservations
Note: Changes or modifications made to this equipment
not expressly approved by may void the FCC
authorization to operate this equipment.
Note: This device complies with Part 15 of the FCC
Rules and with Industry Canada licence-exempt RSS
standard(s).
Operation is subject to the following two conditions:
Product overview
(Fig. 1)
1. Drill spindle
2. Quick release washer
3. Leakage hole
4. Gardena male coupling with water valve
5. Gear selector
6. On/Off switch
7. Handle
™
8. Smartstart
9. LEDs to show power output
10. Electronics box
11. Assembly plate for Husqvarna drill stand
12. PRCD
Note: In this manual we use the term PRCD for
PRCD and GFCI.
13. Water connector
14. Wrench
15. Operator's manual
Symbols on the product
(Fig. 2) WARNING! This product can be dangerous
and cause serious injury or death to the
operator or others. Be careful and use the
product correctly.
(Fig. 3) Read the operator's manual carefully and
make sure that you understand the
instructions before you use this product.
Safety definitions
Warnings, cautions and notes are used to point out
specially important parts of the manual.
WARNING: Used if there is a risk of injury or
death for the operator or bystanders if the
instructions in the manual are not obeyed.
1188 - 008 - 14.09.2020
• this device may not cause harmful interference
• this device must accept any interference received,
including interference that may cause undesired
operation
Intended use
The product is used to drill concrete, rock, asphalt and
masonry. All other use is incorrect.
The product is used in industrial operations by operators
with experience.
(Fig. 4) Always use approved personal protective
equipment. Refer to
equipment on page 10 .
(Fig. 5) Environmental mark.The product or package
of the product is not domestic waste.
Recycle it at an approved disposal location
for electrical and electronic equipment.
(Fig. 6) Make sure that water cannot leak into the
product when you drill in the ceiling. Use an
applicable water collector.
Note: Other symbols/decals on the product refer to
special certification requirements for some markets.
Product liability
As referred to in the product liability laws, we are not
liable for damages that our product causes if:
• the product is incorrectly repaired.
• the product is repaired with parts that are not from
the manufacturer or not approved by the
manufacturer.
• the product has an accessory that is not from the
manufacturer or not approved by the manufacturer.
• the product is not repaired at an approved service
center or by an approved authority.

Safety

CAUTION: Used if there is a risk of damage
to the product, other materials or the
adjacent area if the instructions in the
manual are not obeyed.
Note: Used to give more information that is necessary in
a given situation.
Personal protective
7