Using This Manual; Compliance With The Emc And Low Voltage Directives - Mitsubishi Electric MELSEC Q Series User Manual

Using This Manual

The symbols used in this manual are shown below.
Pr.
.............................. Symbol indicating positioning parameter item.
.............................. Symbol indicating positioning data item.
Da.
Md. .............................. Symbol indicating monitor data item.
Cd.
.............................. Symbol indicating control data item.
(A serial No. is inserted in the
Representation of numerical values used in this manual.
Buffer memory addresses, error codes and warning codes are represented in decimal.
X/Y devices are represented in hexadecimal.
Setting data and monitor data are represented in decimal or hexadecimal. Data ended by "H"
or "h" are represented in hexadecimal.

Compliance with the EMC and Low Voltage Directives

(1) For programmable controller system
To configure a system meeting the requirements of the EMC and Low Voltage Directives when
incorporating the Mitsubishi programmable controller (EMC and Low Voltage Directives
compliant) into other machinery or equipment, refer to Chapter 9 "EMC AND LOW VOLTAGE
DIREVTIVES" of the QCPU User's Manual (Hardware Design, Maintenance and Inspection).
The CE mark, indicating compliance with the EMC and LOW Voltage Directives, is printed on
the rating plate of the programmable controller.
(2) For programmable controller system
For the compliance of this product with the EMC and Low Voltage Directives, refer to Section
4.2 "Wiring" of the chapter 4. And, refer to the EMC Installation Guidelines (IB(NA)67339) for
the servo amplifiers or servo motors.
(Example) 10 Decimal
10h Hexadecimal
mark.)
A - 17