Download Print this page

Frigidaire Professional FPEW3085KF Specifications page 7

30" electric single wall oven
Hide thumbs Also See for Professional FPEW3085KF:

Advertisement

30" Combination Installation Specifications
Always consult local and national electric codes.
(Refer to product-specific electrical specifications on this page.)
Minimum 23-5/8" deep cutout dimension is critical for proper
combination installation, to ensure that each built-in product's
faceplate will fit flush against cabinet front.
Bases must be level and cabinet front must be square.
Minimum 4-1/2" required distance from bottom of Warmer Drawer
cutout to floor.
Respect critical dimensions as noted for proper installation of
built-In products.
Minimum 21" clearance needed for Wall Oven door depth when open.
30" Built-In Microwave Specifications
For built-in installation, microwave MUST be installed with optional
30" Trim Kit which includes Bottom Duct Assembly – shipped in
separate box, ordered by individual part number.
Voltage Rating – 120V / 60 Hz / 15 or 20 Amps
Connected Load (kW Rating) @ 120 Volts = 1.7 kW
(For use on adequately wired 120V, dedicated circuit having 2-wire
service with a separate ground wire. Appliance must be grounded
for safe operation.)
Amps @ 120 Volts = 14.3 Amps
Full oven base of solid plywood or similar material required, capable
of supporting 100 Lbs.
Minimum 2-7/8" clearance required from bottom of Built-In Microwave
cutout to top edge of Wall Oven's faceplate, leaving a 2" visible gap
between both product faceplates.
USA
10200 David Taylor Drive
Charlotte, NC 28262
CANADA
5855 Terry Fox Way
Mississauga, ON L5V 3E4
MOSS_EW_WD 30INST FR 08/10
1-800-FRIGIDAIRE
frigidaire.com
1-800-265-8352
frigidaire.ca
© 2010 Electrolux Home Products, Inc.
30" Combination Installation
Built-In Microwave / Single Wall Oven / Warmer Drawer
30" Electric Single Wall Oven Specifications
Single phase 3- or 4-wire cable, 120 / 240 or 120 / 208 Volt, 60 Hertz
AC only electrical supply with ground required on separate circuit
fused on both sides of line.
For detailed electrical requirements, refer to model-specific product
page and installation guide on web.
To support Wall Oven when using in combination with Warmer
Drawer, two 3"-wide x 3/4"-thick planks must be installed as a base,
capable of supporting 200 Lbs. Do NOT use full base, since planks
are necessary to allow for proper air displacement.
30" Warmer Drawer Specifications
• Voltage Rating – 120V / 450W / 60 Hz / 15 Amps
• Connected Load (kW Rating) @ 120 Volts = 0.5 kW
(For use on adequately wired 120V, dedicated circuit having 2-wire
service with a separate ground wire. Appliance must be grounded
for safe operation.)
• Amps @ 120V = 3.8 Amps
• Full base of solid plywood or similar material required, capable of
supporting 100 Lbs.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at frigidaire.com for detailed instructions.
Specifications
subject to change.
Printed in the U.S.A.

Advertisement

loading

This manual is also suitable for:

Professional fpew3085k f