Electrical Connections - AEG 34942G Operating And Installation Instructions

Electrical connections

Any electrical work required to install this hob should be carried out
by a qualified electrician or competent person, in accordance with the
current regulations.
THIS HOB MUST BE EARTHED.
The manufacturer declines any liability should these safety measures not be
observed.
This hob is designed to be connected to a 230-240V 50Hz AC electrical
supply.
Before switching on, make sure the electricity supply voltage is the same as
that indicated on the hob rating plate. The rating plate is located on the
bottom of the hob. A copy is attached on the back cover of this book.
The hob is supplied with a 3 core flexible supply cord incorporating a 3amp
plug fitted. In the event of having to change the fuse, a 3amp ASTA
approved (BS 1362) fuse must be used.
Should the plug need to be replaced for
any reason, the wires in the mains lead
are coloured in accordance with the
following code:
Green and Yellow - Earth
Blue
Brown
1) Connect the green and yellow
(earth) wire to the terminal in the plug which is marked with the
letter 'E' or the earth symbol
2) Connect the blue (neutral) wire to the terminal in the plug which is
marked with the letter 'N' or coloured black.
3) Connect the brown (live) wire to the terminal in the plug which is
marked with the letter 'L' or coloured red.
Upon completion there must be no cut, or stray strands of wire present and
the cord clamp must be secure over the outer sheath.
In the event of having to change the fuse, a 3amp ASTA approved (BS 1362)
fuse must be used.
A cut off plug inserted into a 13 amp socket is a serious safety
(shock) hazard. Ensure that the cut off plug is disposed of safely.
20
- Neutral
- Live
FO 0390
or coloured green and yellow.