Troubleshooting; Irregular Temperature Control; Heater Element Check - Idex Trebor INLINE DI Operation & Maintenance Manual

Hide thumbs Also See for Trebor INLINE DI:
Table of Contents

Advertisement

6

TROUBLESHOOTING

The following is an outline of routine troubleshooting techniques. For conditions
not covered in this section consult Trebor or a factory authorized representative.
6.1

IRREGULAR TEMPERATURE CONTROL

SYMPTOM
Poor Temperature Control
Heater Does Not Heat
6.2

HEATER ELEMENT CHECK

Lockout and Tagout power to the heater. Disconnect the heater power electrical
connections and measure the resistance between power wires or to the neutral
wire. Resistance should be less than the values listed in Table 6-1.
Heater Power
6-kW, 3Ø
PAGE 14
CAUSES
Low liquid flow
Location of outlet
temperature sensor
Incorrect control settings
Failed heater
Wiring short
Interlock alarm
Control system error
Power Wire to
Power Wire
<52Ω
Table 6-1: Element Resistance Check
MODEL IDH OPERATION / MAINTENANCE MANUAL
SOLUTIONS
Increase flow
Relocate outlet
temperature sensor
closer to heater outlet
Adjust control settings or
scheme
Check heater element per
Section 6.2
Check heater wiring
Address system alarms
Evaluate controller
Power Wire to
Neutral Wire
N/A

Advertisement

Table of Contents
loading

Table of Contents