Setting The Water Softener - Electrolux ESI 66065 User Manual

SETTING THE WATER SOFTENER

The water softener removes minerals and
salts from the water supply. These minerals
and salts can cause damage to the appli-
ance.
German degrees
(°dH)
51 - 70
43 - 50
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
< 4
1) Factory position.
2) Do not use salt at this level.
You must adjust the water softener man-
ually and electronically.
Manual adjustment
Turn the water hardness dial to the position
1 or 2 (refer to the table).
Electronic adjustment
1. Switch on the appliance.
2. Make sure that the appliance is in set-
ting mode.
3. Press and hold function buttons B and
C until the indicator lights of function but-
tons A, B and C start to flash.
Water hardness
French degrees
(TH°)
91 - 125
76 - 90
65 - 75
51 - 64
40 - 50
33 - 39
26 - 32
19 - 25
7 - 18
< 7
Adjust the level of the water softener if this
does not agree with the water hardness in
your area.
Contact your local water authority to know
the water hardness in your area.
mmol/l Clarke de-
grees
9,1 - 12,5 64 - 88
7,6 - 9,0 53 - 63
6,5 - 7,5 46 - 52
5,1 - 6,4 36 - 45
4,0 - 5,0 28 - 35
3,3 - 3,9 23 - 27
2,6 - 3,2 18 - 22
1,9 - 2,5 13 - 17
0,7 - 1,8 5 - 12
< 0,7 < 5
4. Release function buttons B and C.
5. Press function button A.
– The indicator lights for function but-
tons B and C go off.
– The indicator light for function button
A continues to flash.
– The display shows the current adjust-
ment.
Example: the display shows
5.
6. Press the function button A again and
again until the display shows the neces-
sary adjustment.
7. Press the on/off button to keep the op-
eration.
If the water softener is set electronically
to the level 1, the salt indicator light
stays off.
electrolux 21
Water hardness ad-
justment
manually elec-
troni-
cally
1) 10
2
1)
9
2
1)
8
2
1)
7
2
1)
6
2
1) 1)
2 5
1 4
1 3
1 2
2) 2)
1 1
= level