Placement Of Mounting Plate; Removing The Mounting Plate; Finding The Wall Studs - Frigidaire GLMV168C Installation Instructions Manual

Over the range microwave oven
Hide thumbs Also See for GLMV168C:
Table of Contents

Advertisement

1
PLACEMENT OF THE MOUNTING PLATE
.
REMOVING THE MICROWAVE
A
OVEN FROM THE CARTON/
REMOVING THE MOUNTING
PLATE
1
Remove the installation instructions, filters, glass
tray and the small hardware bag. Do not remove
the Styrofoam protecting the front of the oven.
2
Fold back all 4 carton flaps fully against carton
sides. Then carefully roll the oven and carton over
onto the top side. The oven should be resting in
the Styrofoam.
Styrofoam
3
Pull the carton up and off the oven.
4
Remove and properly discard plastic bags.
Screws
5
Remove the 2 screws from the mounting plate.
This plate will be used as the rear wall template
and for mounting. You may discard these screws.
Installation Instructions
Carton
Mounting
Plate
.
B

FINDING THE WALL STUDS

Wall
Studs
Center
1
Find the studs, using one of the following
methods:
A. Stud finder – a magnetic device which
locates nails.
B. Use a hammer to tap lightly across the
mounting surface to find a solid sound.
This will indicate a stud location.
2
After locating the stud(s), find the center by
probing the wall with a small nail to find the edges
of the stud. Then place a mark halfway between the
edges. The center of any adjacent studs should be
16 or 24 (40.64 cm or 60.96 cm) from this mark.
3
Draw a line down the center of the studs.
THE MICROWAVE MUST BE CONNECTED TO
AT LEAST ONE WALL STUD.
8
OR

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents