Table of Contents
Advertisement
1
PLACEMENT OF THE MOUNTING PLATE
.
REMOVING THE MICROWAVE
A
OVEN FROM THE CARTON/
REMOVING THE MOUNTING
PLATE
1
Remove the installation instructions, filters, glass
tray and the small hardware bag. Do not remove
the Styrofoam protecting the front of the oven.
2
Fold back all 4 carton flaps fully against carton
sides. Then carefully roll the oven and carton over
onto the top side. The oven should be resting in
the Styrofoam.
Styrofoam
3
Pull the carton up and off the oven.
4
Remove and properly discard plastic bags.
Screws
5
Remove the screws from the mounting plate.
This plate will be used as the rear wall template
and for mounting. Reinstall the screws into the
holes where they were removed.
Installation Instructions
Carton
Mounting
Plate
.
B
FINDING THE WALL STUDS
Wall
Studs
Center
1
Find the studs, using one of the following
methods:
A. Stud finder – a magnetic device which
locates nails.
B. Use a hammer to tap lightly across the
mounting surface to find a solid sound.
This will indicate a stud location.
2
After locating the stud(s), find the center by
probing the wall with a small nail to find the edges
of the stud. Then place a mark halfway between
the edges. The center of any adjacent studs should
be 16" (40.6 cm) or 24" (61 cm) from this mark.
3
Draw a line down the center of the studs.
THE MICROWAVE MUST BE CONNECTED TO
AT LEAST ONE WALL STUD.
8
OR
Hide quick links:
Advertisement
Table of Contents
