MOUNT THE MICROWAVE
Insert 2 self-aligning screws
through outer top cabinet
holes. Turn two full turns on
Tighten the outer two screws to the top of the
microwave oven. (While tightening screws, hold
the microwave oven in place against the wall and
the top cabinet.)
Install grease filters. See the Owner's Manual
packed with the microwave.
NOTE: The charcoal filter is factory installed in
recirculating models. Follow these steps to replace a
filter or to install a filter after converting a vented
model to recirculating operation.
Remove screws on front of grille using a
#1 Phillips screwdriver.
Open the door.
Remove the grille.
Pull the grille straight off.
Install the charcoal filter. When properly installed,
the wire mesh of the filter should be visible from
Replace the grille and the screws.
Close the door.
Insert mesh-side up