Software Design; User Interface; System Module - Fujitsu F2MC-8FX Series User Manual

Induction Heater C Library V1.1
Chapter 9 10BDemo System

9.2 Software Design

9.2.1 User Interface

The system has six work modes. You can press <M and M> to change the work mode.
When power on, the system is standby. When you press On/off, it will work under thaw
mode. In any mode, you can press On/off to turn off or press +/ - to change the watt or the
time when you are setting the timer. When you want to heat food by timer, you can press
Timing to set and start the timer. And you can press Cancel to cancel the timer. You can
press View to view the timer. If the time is zero, the timer is not started.

9.2.2 System Module

MCU-AN-500089-E-11 – Page 21