Frigidaire CGLMV168 Use & Care Manual page 8

IMPORTANT SAFETY INFORMATION
READ ALL INFORMATION
BEFORE USING
Microwave-Safe Cookware
• Use foil only as directed in this manual.
TV dinners may be microwaved in foil
trays less than 3/4 (2 cm) high; remove
the top foil cover and return the tray to
the box. When using foil in the
microwave oven, keep the foil at least
1 inch (2.5 cm) away from the sides of
the oven.
• Plastic cookware—Plastic cookware
designed for microwave cooking is very
useful, but should be used carefully.
Even microwave-safe plastic may not be
as tolerant of overcooking conditions as
are glass or ceramic materials and may
soften or char if subjected to short
periods of overcooking.
The Exhaust Fan
The fan will operate automatically under
certain conditions (see Automatic Fan
feature). Take care to prevent the starting
and spreading of accidental cooking fires
while the exhaust fan is in use.
• Clean the underside of the microwave
often. Do not allow grease to build up
on the microwave or the fan filters.
• In the event of a grease fire on the
surface units below the microwave oven,
smother a flaming pan on the surface
unit by covering the pan completely
with a lid, a cookie sheet or a flat tray.
In longer exposures to overcooking,
the food and cookware could ignite.
Follow these guidelines:
1. Use microwave-safe plastics only and
use them in strict compliance with
the cookware manufacturer's
recommendations.
2. Do not microwave empty containers.
3. Do not permit children to use plastic
cookware without complete supervision.
• Use care when cleaning the exhaust fan
filters. Corrosive cleaning agents, such
as lye-based oven cleaners, may damage
the filters.
• When preparing flaming foods under
the microwave, turn the exhaust fan on.
• Never leave surface units beneath your
microwave oven unattended at high heat
settings. Boilovers cause smoking and
greasy spillovers that may ignite and
spread if the microwave exhaust fan is
operating. To minimize automatic fan
operation, use adequate sized cookware
and use high heat on surface units only
when necessary.
8
(continued)