GREEN POWER CORD
GREEN
GROUND WIRE
SILVER TERMINAL
G R O U N D
S C R E W
TERMINAL BLOCK
TIGHTEN
BLACK
N E U T R A L
N U T
G R O U N D
TO THESE
WHITE
W I R E
T H R E A D S
NUT
RED
STRAIN
RELIEF
MOUNTING
BRACKET
POWER
C O R D
ELECTRICAL CONNECTIONS
FOR 4-WIRE SYSTEM
ELECTRIC Dryer
1. Remove the screws securing the terminal block access
cover and the strain relief mounting bracket located on
the back of the dryer upper corner.
2. Install a U.L. approved strain relief in the entry hole of
the mounting bracket. Finger tighten the nut only at this
time.
3. Remove the ground wire from the green ground screw
located above the terminal block.
TYPICAL 4
BLACK 240V
C O N D U C T O R
WHITE NEUTRAL
RED 240V
TYPICAL 4
C O N D U C T O R
GREEN GROUND
30 AMP NEMA 14-30 TYPE SRDT OR ST
4. Thread a U.L. approved 30 amp power cord, NEMA 14-30
type ST or SRDT through the strain relief.
5. Attach the green power cord ground wire to the cabinet
with the green ground screw.
6. Attach the white (neutral) power cord conductor from the
power cord and the ground wire from the dryer harness to
the silver-colored center terminal on the terminal block.
Tighten the screw securely.
7. Attach the red and black power cord conductors to the
outer brass-colored terminals on the terminal block.
Do not make a sharp bend or crimp wiring/
conductor at the connections.
8. Tighten the screws securing the cord restraint firmly
against the power cord.
9. Tighten the strain relief nut securely so the strain relief
does not turn.
10. Reinstall the terminal block access cover.
Page 10