Instructions - Frigidaire FDBL960BS1 Use And Care Manual

Operating Instructions
Status Indicator Lights
The SENSING light comes on at the beginning of
the selected cycle and will remain on until the end
of the sensing sequence.
The WASHING light comes on at the beginning of
cycle and remains on until the end of the main
wash.
The DRYING light indicates the drying portion of
the cycle. The light will come on when either
drying option is selected.
When the SANITIZE option is selected, the
SANITIZED light will glow when the SANITIZE
cycle is finished. If the dishwasher did not properly
sanitize the dishes, the light will not come on. This
can happen if the cycle is interrupted. The light will
remain on until the door is opened.
The CLEAN light will come on at end of cycle and
remain on until door is opened.
Child Lock Controls
To prevent children from accidently changing the
dishwasher cycle or starting the dishwasher, lock
the dishwasher controls by pressing and releasing
the NO HEAT DRY pad, then pressing and holding
the NO HEAT DRY pad for 5 seconds. The
CONTROLS light will come on and no new
selections can be made until the lock is released.
To unlock the controls, press the NO HEAT DRY
pad for 5 seconds until the CONTROLS light goes
out.
(continued)
Status Window
The STATUS window, available on some models,
indicates the following activity:
Note: The time remaining could suddenly increase
or drop several minutes. This means the Smart
Sensor has checked the soil level and determined
if additional water fills are needed or if water fills
can be deleted.
1H-9H.............
CL..................
HO.................
MINUTES.........
PF..................
LO ....................
7
Number of delay start hours.
The last hour will count down in
minutes.
Close dishwasher door. The
status indicator lights will also
flash to indicate current cycle
status.
Flashes to indicate a water heat
delay.
Number of minutes left in cycle
(1-99). If cycle is longer than 99
minutes, a small light will
appear in the lower right corner
and remain on until time counts
below 99.
Appears in window when
dishwasher is first installed, or
when power has been
interrupted. HI-TEMP WASH
and NO HEAT DRY indicator
lights will also flash. To clear,
touch START/CANCEL pad.
Will be displayed at the end of
the cycle when the rinse aid
dispenser needs refilling. It will
remain on until the door is
opened and will appear after
completion of each cycle until
the rinse aid dispenser is filled.