Delay Start; To Cancel A Cycle - Frigidaire FDB2310LCS0 Use And Care Manual

Operating Instructions
Options Selections
Hi-Temp Wash
When HI-TEMP WASH option is selected, the
dishwasher heats water in the main wash to
approximately 140°F (60°C).
This increase in water temperature helps
dishwasher detergent remove food grease and
soil from dishes more effectively and aids in
drying. HI-TEMP WASH option can be used with
all cycles except CHINA CRYSTAL (some models)
and RINSE & HOLD. HI-TEMP WASH is automati-
cally provided when POTS & PANS cycle is
selected.
When HI-TEMP WASH option is selected, the
light above the pad will come on and remain on
until end of cycle. To turn off the HI-TEMP WASH
option, press the pad a second time. The light
above the pad will turn off.
Sanitize Option
To sanitize your dishes and glassware, select the
SANITIZE option. When selected, the light above
the pad will come on and remain on until end of
cycle. The water temperature in the final rinse will
be raised to 155°F (68°C) and will maintain that
temperature for 9 minutes. This option is available
in Pots & Pans, Normal and Light (Both Racks)
cycles. Only these sanitization cycles have been
designed to meet NSF requirements.
The cycle time will be extended until the proper
water temperature is reached. Washing action will
continue during the water heating delay. For best
results, the incoming water temperature should be
at least 120°F (49°C).
The sanitize criteria may not be satisfied if there is
an interruption of the cycle, power failure or if the
incoming water temperature is below 120°F
(49°C).
To turn off the SANITIZE option, press the pad a
second time. The light above the pad will turn off.
No Heat Dry
NO HEAT DRY option saves electricity since the
heating element is off during drying portion of
cycle. When selected, the light above the pad will
come on and remain on until end of cycle. To
(continued)
speed the drying process, open the door slightly
after the cycle is complete. Some water droplets
may remain on door and tub and in areas where
dishes touch silverware basket and rack.
To select heated dry, press the pad a second
time. The light above the pad will turn off. Heated
dry provides faster drying since the heating
element is on during the drying portion of the
cycle.
You may see water vapor coming from the vent
during the drying portion of cycle. The vent is
closed during washing to hold moisture and sound
inside. The vent opens during the last few minutes
of the final rinse and remains open for drying. The
drying option may be changed at any time during
the cycle and affects only the drying period.
Opening the door longer than one minute during
the dry cycle cancels the selected dry program.

Delay Start

The DELAY START option allows you to
automatically delay starting your dishwasher from
1-10, 1-24 or 2-4-6 hours depending on your
model.
On models with 1-10 or 1-24 hour delay, press the
DELAY START pad until the desired delay time
shows in the STATUS window. A light will come
on indicating the delay start hours and will remain
on until cycle starts.
On models with 2-4-6 hour delay, press the pad
once for a 2 hour delay, twice for 4 hours and
three times for 6 hours. A light will come on
indicating the delay start hours and will remain on
until cycle starts.
To cancel the DELAY START option and begin the
cycle before the delay period is over, press the
START/CANCEL pad.

To Cancel a Cycle

You can cancel a cycle anytime during the cycle.
Press START/CANCEL pad and the dishwasher
will start a 90 second drain. At the end of the
drain, select the desired cycle.
6