Anthropologie Odetta Single Vanity Assembly Instructions

Do not throw away packing materials and carton until after assembly.

Assemble all parts on a clean smooth surface

Care Instructions:

Avoid direct exposure to sunlight. Do not place over heat or Air conditioning vents.

Adjust levelers so that the furniture sits flat on uneven floors.

Blot spills do not rub, with a clean white cloth.

Do not use harsh chemicals.

Before cleaning any part test a small spot in a hidden area.

You will need to Seek the help of a Professional Plumber for complete installation.

1. Remove all shelves from inside the vanity. With help lay the vanity over onto a clean smooth surface. Align

legs as shown below. Insert Bolt (3), Lock washer (4), and Flat washer (5). Tighten with supplied hex (9).

With help stand the vanity upright without leaning it on the legs as this can damage them.

unauthorized reproduction, adaptation, distribution or other infringement will be prosecuted.

Rev 1 05.10.19

EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.

Odetta Single Vanity

Assembly Instructions

Page 1 of 4

Table of Contents

Do you have a question about the Odetta Single Vanity and is the answer not in the manual?

Page 1 Odetta Single Vanity Assembly Instructions Do not throw away packing materials and carton until after assembly. Assemble all parts on a clean smooth surface Care Instructions: Avoid direct exposure to sunlight. Do not place over heat or Air conditioning vents.
Page 2 Odetta Single Vanity Assembly Instructions 2. Insert shelf holders into the side panels as shown. Carefully lay the shelf onto the holders. Insert screws (2) through the holders into the bottom of the shelf. EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
Page 3 Odetta Single Vanity Assembly Instructions 3. With help carefully lay the Marble Top (D) over onto a clean smooth surface. Carefully align the sinks (F) as shown. You may want to add a small bead of clear silicon caulking around the sink holes on the bottom of the marble top before aligning the sinks.
Page 4 Odetta Single Vanity Assembly Instructions 5. Once the vanity is in place and plumbed to the house plumbing you can add the backsplash (E). Carefully apply a bead of caulk to the bottom edge of the backsplash and with help align it to the top of the vanity.