Advertisement
M.-Nr. 09469886
Stand installation
Removing the drawer from the stand
A
Pull the drawer all the way out; see Fig. 2.
A
Press the spring catches while lifting the drawer upward; see Fig. 3.
Installing the stand under a dryer
A
Empty the condensate container.
A
Screw the dryer feet in fully with a pipe wrench.
A
Remove the set screws from the stand with a 5 mm Allen key (A); see Fig. 4. These set screws will no longer be
needed.
A
Install the supplied 10 x 40 mm set screws as far as possible into the threaded bolts (B); see Fig. 4.
WARNING
Risk of crushing fingers if they are trapped between the dryer casing and the set screws.
A
Do not lift the dryer at the corners.
A
Lift the dryer onto the stand and guide the set screws into the openings in the dryer feet; see Fig. 5.
A
Install the sealing strips as shown on the inside of the rear panel; see Fig. 6.
A
Loosen the screws on the eccentric cams (1) on the dryer rear panel; see Fig. 7
The eccentric cams may move slightly when their screws are loosened. To ensure safe installation, the eccentric cams
must be returned to the starting position: Engaging tooth in the bottom left at a 20° angle (1); see Fig. 7.
A
Use 1 CEM 4 x 10 raised-head screw to install the rear panel on the stand at the bottom (2); see Fig. 7.
A
Hook the connection pieces (3) onto the screws on the eccentric cams; see Fig. 7.
A
Use 2 CEM 4 x 10 raised-head screws to install the connection pieces and the rear panel on the stand at the top (1);
see Fig. 8.
A
Tighten the screws on the eccentric cams (2); see Fig. 8.
A
Level the machine and stand using a spirit level.
A
Counter the stand feet.
A
Secure the stand to the floor with the floor fastening kit, mat. no. 06593051.
Installing the stand under the washer
Before the actual assembly, the connection pieces are secured on the stand. They are used to connect two stands
securely together. Tighten the connection pieces even if a second stand is not to be used. This will avoid possibly
difficult retrofitting and also ensures that the connection pieces are stored safely.
Installation of dryer on left and washing machine on right: See Fig. 9.
Installation of dryer on left and washing machine on right: See Fig. 10.
A
Use a pipe wrench to hold the threaded bolts in the stand and remove the stand feet.
A
Unscrew two stand feet from the left or right side, depending on the installation setup; see Fig. 9 or Fig. 10.
A
Install the washers on the drip pan; see Fig. 9 or Fig. 10.
A
Install the connection pieces (1) on the washers; see Fig. 9 or Fig. 10.
A
Screw on the stand feet but don't secure them with the counter nuts yet.
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
35 von 83
26.02.2021
Advertisement
