Electrical Connection - Miele DA 2668 Operating And Installation Instructions

Installation
In recirculation mode, the silencer
needs to be positioned between the
exhaust vent and the exhaust grille .
Check that there is sufficient space.
For operation with an external motor,
noise from the motor outside the house
and inside the kitchen can be
minimised.
Positioning the silencer in front of the
external motor  reduces noise inside
the kitchen. If the exhaust ducting is
long, the silencer needs to be
positioned at the exhaust duct in the
ducting above the cooker hood itself .
For an external motor installed inside
the house, noise from the motor outside
the house can be reduced by
positioning the silencer behind the
external motor .
48

Electrical connection

Refer to the notes in "Electrical
connection" and "Warnings and
safety notes" before connecting to
the power supply.
The connection data (voltage,
frequency) on the data plate must
match the data of the mains power
supply. The position of the data plate is
explained in the "Service" chapter.
The cooker hood is equipped with a
power cable and a safety plug.
The connection must be made via a
socket which remains accessible after
the cooker hood has been installed. If
the socket is no longer accessible after
installation or if you are using a hard-
wired connection, there must be a
suitable means of disconnection for all
poles in the household electrical system
which meets the requirements of
overvoltage category III.
Safety can be increased by fitting the
appliance with a residual current
device.
Only qualified electricians are permitted
to carry out work on the household
electrical system.
This appliance must be earthed.