Reset Method For The Protective Functions - Mitsubishi Electric 800 Series Instruction Manual

Hide thumbs Also See for 800 Series:
Table of Contents

Advertisement

2.2

Reset method for the protective functions

Reset the inverter by performing any of the following operations. Note that the accumulated heat value of the electronic thermal
relay function and the number of retries are cleared (erased) by resetting the inverter.
The inverter recovers about 1 second after the reset is released.
• On the operation panel, press the STOP/RESET key to reset the inverter. (This may only be performed when a fault occurs.
(Refer to
page 22
of the Instruction Manual for faults.))
• Switch the power OFF once, then switch it ON again.
ON
OFF
• Turn ON the Reset (RES) signal for 0.1 s or more. (If the RES signal is kept ON, "Err" appears (blinks) to indicate that the
inverter is in a reset status.)
Inverter
RES
SD
NOTE
• OFF status of the start signal must be confirmed before resetting the inverter fault. Resetting an inverter fault with the start
signal ON restarts the motor suddenly.
2. Protective Functions
2.2 Reset method for the protective functions
1
2
3
4
5
6
7
8
9
10
13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents