Chapter 2 System Configuration - Mitsubishi Electric MELSEC iQ-R Series User Manual

2
SYSTEM CONFIGURATION
This section describes the system configuration in which the Camera recording package is used.
(4)
(5)
(2)
No. Device name
(1) Programmable controller
(2) Network camera
(3) Network storage
(4) Personal computer
(5) PoE switching hub
(6) Ethernet (twisted pair) cable
• The IP address needs to be set for the programmable controller, network camera, and network storage. Set
all the IP addresses into the same segment.
• When multiple network cameras are connected simultaneously, connect multiple external storages. A single
external storage may be insufficient for saving video files.
• Up to 16 network cameras can be used at the same time.
2 SYSTEM CONFIGURATION
12
(3)
Description
Page 13 Compatible Programmable Controllers
• Ethernet-connectable camera ( Network cameras supporting the Camera recording package (FA-A-0306))
• The number of connectable network cameras varies depending on the number of simultaneous open TCP/IP
connections. For details, refer to the following.
 MELSEC iQ-R Ethernet/CC-Link IE User's Manual (Startup)
 QnUCPU User's Manual (Communication via Built-in Ethernet Port)
Storage for saving video files
• Used to set the network camera, write programs, and play back video files.
• For the operating environment, refer to the following.
 GX Works3 Installation Instructions
 GX Works2 Installation Instructions
• When using GX VideoViewer, refer to the following.
 GX VideoViewer Version 1 Operating Manual
A switching hub capable of PoE power supply
For the compatible Ethernet cables, refer to the manual for the device to be used.
(1)
(6)