U.s. Customary Units - Mitsubishi Electric MELSERVO J5 Series User Manual

Interpreting servo parameter numbers
For a servo parameter which uses one particular digit to select a function, the position of its digit indicates the detail number of
the servo parameter, and the value in hexadecimal which is set to the digit indicates the selected function.
For example, the detail number of the servo parameter in the last digit is expressed as [Pr. PA01.0]. In addition, a servo
parameter which uses a combination of several digits to select a function, is expressed using "-" as seen in [Pr. PA01.0-1].
The following is an example of the servo parameter number PA01 with the setting values of "FEDCBA98" in hexadecimal.
• When setting a servo parameter with one particular digit
[Pr. PA01] =
F E D C
• When setting a servo parameter using a combination of several digits
[Pr. PA01] =
F E D C
For example, if the servo parameter name is "Function selection A-1", the setting digit name is "Forced stop deceleration
function selection", and the setting digit is the forth last digit in PA04, the servo parameter is expressed as shown below.
[Pr. PA04.3 Forced stop deceleration function selection]
Servo Symbol
parameter
PA04.3 *AOP

U.S. CUSTOMARY UNITS

U.S. customary units are not shown in this manual. Convert the values if necessary according to the following table.
Quantity
Mass
Length
Torque
Moment of inertia
Load (thrust load/axial load)
Temperature
4
B A 9 8
Detail No.
PA01.0 = "8"
PA01.1 = "9"
PA01.2 = "A"
PA01.3 = "B"
PA01.4 = "C"
PA01.5 = "D"
PA01.6 = "E"
PA01.7 = "F"
B A 9 8
Detail No.
PA01.0-1 = "98"
PA01.2-4 = "CBA"
PA01.5 = "D"
PA01.6 = "E"
PA01.7 = "F"
Name
Forced stop deceleration function
selection
SI (metric) unit
1 [kg]
1 [mm]
1 [N•m]
-4
1 [(× 10
1 [N]
N [°C] × 9/5 + 32
Description
Set "Forced stop deceleration function" to enabled/disabled.
Initial value: 1h (enabled)
2
kg•m )]
U.S. customary unit
2.2046 [lb]
0.03937 [inch]
141.6 [oz•inch]
2
5.4675 [oz•inch ]
0.2248 [lbf]
N [°F]