Pair Up With The Subwoofer - Philips 6000 Series User Manual

Pair up with the subwoofer

Automatic Pairing
Plug the Soundbar and the subwoofer into
the mains sockets and then press on the unit
or remote control to switch the unit to ON
mode. The subwoofer and Soundbar will
automatically pair.
Determine the status based on the
wireless subwoofer indicator.
LED State Status
Fast blink Subwoofer in pairing mode
Constant on Connected / Pairing successful
Slow blink Connection / Pairing Failed
Tips
Do not press Pair on the rear of the subwoofer, except
for manual pairing.
Manual Pairing
If no audio from the wireless subwoofer can
be heard, manually pair up the subwoofer.
1
Unplug both units from the mains
sockets again, then plug them in again
after 3 minutes.
2
Press and hold the Pair button on the
rear of the subwoofer for a few seconds.
The Pair indicator on the subwoofer
will rapidly blink.
3
Then press on the unit or remote
control to switch the unit ON.
The Pair indicator on the subwoofer
will become solid when successful.
4
If the Pair indicator still keeps blinking,
repeat step 1-3.
Tips
The subwoofer should be within 6 m of the Soundbar
in an open area (the closer the better).
Remove any objects between the subwoofer and the
Soundbar.
If the wireless connection fails again, check if there is
a con ict or strong interference (e. g. interference from
an electronic device) around the location. Remove
these con icts or strong interferences and repeat the
above procedures.
If the main unit is not connected with the subwoofer
and it is in ON mode, the unit's STANDBY indicator
will ash.
11