•
1.5.3
Supported Fiber Optic Cables
The following fiber optic cable types are supported under the stated conditions.
Cable Type
Wavelength (nm)
OM1 (62.5/125)
OM2 (50/125)
a
OM3 (50/125)
a
OM4 (50/125)
a
Laser optimized.
1.6
Tamper-Evident Security Seals
In compliance with the security requirements of the Federal Information Processing
Standards (FIPS140-2), FIPS-compliant tamper-evident security seals are applied to
potential access points on this device. Security seals provide evidence of unautho-
rized tampering or removal of components.
NOTICE
Worn, damaged or missing seals must be replaced immediately.
Replacement seals are available for purchase from Siemens. For more information,
contact a Siemens Sales representative.
There are three ways to determine if a security seal has been tampered with:
•
•
•
For information about the placement of security seals, refer to the
RUGGEDCOM RSG2200F FIPS 140-2 Non-Proprietary Security Policy [https://sup-
port.industry.siemens.com/cs/ww/en/view/109757984]
RUGGEDCOM RSG2200F
Installation Manual, 01/2020, C79000-G8976-1346-06
Shielded/screened cabling can be used when required. Care should be taken to
avoid the creation of ground loops with shielded cabling.
Modal Band-
width (MHz·km)
850
200
1300
500
850
500
1300
500
850
1500
1300
500
850
3500
1300
500
The seal is cut or torn
A pattern is left on the device when the top layer of the seal is removed
Residue left by the seal is visible on the device under ultra-violet light
1.5.3 Supported Fiber Optic Cables
Distance (m)
100Base-FX
1000Base-SX
—
275
2000
—
550
2000
—
550
2000
—
550
2000
.
Introduction
10GBase-SR
33
—
—
82
—
—
300
—
—
400
—
—
RUGGEDCOM
5