Sony ICD-TX50 Operating Instructions Manual page 9



Preparing the Recorder
Rear
 Clip
 POWER•HOLD switch
 microSD card slot
  (headphone) jack
 RESET button
You can reset the IC recorder by
pressing the button with a small pin,
etc. (  p. 104).
Attaching the noise damper
By attaching the noise damper to the
IC recorder, you can reduce
vibration noises from a table or
other surface where the IC recorder
is placed.
Align the lower part of the noise
damper to the recorder at an angle
(), and then press the logo part
(), so that the noise damper clicks
in place.

To remove the noise damper
Lift the upper part of the noise damper
(in the reverse direction as described in
), and then remove it.

Tip
The noise damper is for decreasing the
possible noise from a table. When you
attach the IC recorder to your clothes,
remove the noise damper from the IC
recorder.