Installation; Appropriate Installation Location; Connecting Water Supply - Beko BDF1410X User Manual

Installation

3
Refer to the nearest Authorised Service
Agent for installation of your product. To
make the product ready for use, make sure
that the electricity, tap water supply and
water drainage systems are appropriate
before calling the Authorised Service Agent.
If they are not, call a qualified technician
and plumber to have any necessary
arrangements carried out.
C
Preparation of the location and
electrical, tap water and waste
water installations at the place
of installation is the customer's
responsibility.
B
Installation and electrical
connections must be carried
out by the Authorised Service
Agent. Manufacturer shall not
be held responsible for damages
arising from processes carried
out by unauthorised persons.
A
Prior to installation, visually
check if the product has any
defects on it. If so, do not have
it installed. Damaged products
cause risks for your safety.
C
Make sure that the water inlet
and discharge hoses are not
folded, pinched or crushed
while pushing the product into
its place after installation or
cleaning procedures.
When placing the product, pay attention not
to damage the floor, walls, piping, etc. Do
not hold the product by its door or panel to
move it.
Dishwasher / User's Manual
Appropriate installation
location
Place the product on a solid and flat
•
floor that has sufficient load carrying
capacity! The product must be installed
on a flat surface in order for the door to
be closed comfortably and securely.
Do not install the product at places
•
where temperature may fall below 0ºC.
Place the product at least 1 cm away
•
from the edges of other furniture.
Place the product on a rigid floor. Do
•
not place it on a long pile rug or similar
surfaces.
B
Do not place the product on the
power cable.
Make sure that you select a location
•
that will allow you to load and unload
the dishes in a fast and comfortable
manner.
Install the product in a place close to
•
the tap and the drain hole. Select the
installation location by considering
that it will not be changed after the
connections are made.

Connecting water supply

C
We recommend attaching a
filter on the house/apartment
supply water inlet to protect the
machine from damages that
may arise from impurities (sand,
dirt, rust, etc.) coming from the
urban water supply system or
from your own water system as
well as to prevent complaints
such as yellowing or sludge
accumulation at the end of
washing.
9 / 42 EN