Whirlpool W10836808B User Instructions page 9

Use automatic dishwasher detergent only. Add detergent
■
just before starting a cycle.
Fresh automatic dishwasher detergent results in better
■
cleaning. Store tightly closed detergent container in a cool
dry place.
To close lid
Place selected detergent in
the dispenser. Place finger, as
shown, and slide lid closed.
Press firmly until it clicks.
Powders and Gels
Water Soil Level
Hardness
Soft Light
(0-4 grains
Normal
per U.S.
gallon) Heavy
Medium Light
(5-9 grains
Normal
per U.S.
gallon) Heavy
Hard Light
(10-14 grains
Normal
per U.S.
gallon) Heavy
*The prewash compartment is on top of the sliding door of
the dispenser.
**A full main wash compartment contains 2 Tbsp (30 ml).
IMPORTANT: Extremely hard water mineral deposits (15 grains
per U.S. gallon or more) can cause damage to your dishwasher
and make it difficult to achieve good results. A water softener is
recommended to avoid damage and achieve good results.
NOTE: Follow instructions on the package when using other
dishwasher detergent types.
Rinse Aid
IMPORTANT: Your dishwasher is designed to use rinse aid.
The use of rinse aids greatly improves drying by allowing water
to drain from the dishes after the final rinse. Rinse aid also keeps
water from forming droplets that can dry as spots or streaks.
To open lid
Push OPEN, as shown,
and the lid will slide open.
Prewash Main Wash
Compartment* Compartment
None "Soft" fill line
None "Soft" fill line
Full "Soft" fill line
None "Soft" fill line
Full Full**
Full Full**
Full Full**
Full Full**
Full Full**
STEP 3
Filling the dispenser
The dispenser holds 5 oz (150 mL) of rinse
aid. Under most conditions this will last
1 to 3 months.
NOTE: Indicator reads correct fill level
when door is completely opened.
1. To add rinse aid, open the
rinse dispenser lid by gently
pushing in the center of the lid
with your thumb and pulling
up on the edge.
2. Pour rinse aid into the
opening until the dispenser
is full. Do not overfill.
3. Clean up any spilled rinse aid.
Spilled rinse aid can create excessive suds.
4. Then, close the dispenser by pushing down
gently on the lid.
Rinse Aid Setting
Your rinse aid dispenser is adjustable. For most
water conditions, the factory setting will give
good results. If you have hard water and notice
calcium buildup on your dishware, you may want
to try a higher setting. If you notice foam in your
dishwasher, use a lower setting.
To adjust the setting:
Turn the arrow adjuster to a higher number
to increase the amount of rinse aid.
Select a Cycle
Efficient dishwashers run longer to save water and energy, just
as driving a car slower saves gas. Cycle times may increase or
decrease depending on selections. Estimated cycle times after
calibration are listed in the "Cycle and Option Descriptions"
chart in the following section. Select the desired cycle by
pressing the Cycles button. Each time you press the Cycles
button, it will advance to the next available cycle.
Select Options
See the "Cycle and Option Descriptions" chart in the
following section.
You can customize the cycles by pressing the options
desired and pressing Start/Resume.
STEP 4
Full
Add
9