Dynamic Ip (Dhcp) - D-Link DVA-2800 User Manual

Section 4 - Configuration
Select Dynamic IP (DHCP) to obtain an IP address automatically from your ISP. Select this
option if your ISP does not provide you with a specific IP address.
IPv4 Settings:
My Internet Select Dynamic IP (DHCP).
Connection is:
Advanced Settings
Host Name: The host name is optional but may be required by some ISPs. Leave
it blank if you are not sure.
Primary DNS Enter the primary DNS server IP address assigned by your ISP. This
Server: address is usually obtained automatically from your ISP.
Secondary DNS
Enter the secondary DNS server IP address assigned by your ISP. This
Server: address is usually obtained automatically from your ISP.
MTU: Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your ISP.
MAC Address
The default MAC address is set to the Internet port's physical interface
Clone: MAC address on the router. You can use the drop-down menu to
replace the Internet port's MAC address with the MAC address of a
connected client.
Enable NAT: Enable or disable Network Address Translation.
Proceed to IPv6 Settings on page 38 or click Save when you are done.
D-Link DVA-2800 User Manual

Dynamic IP (DHCP)

IPv4 SETTINGS
My Internet Connection is: Dynamic IP (DHCP)
Host Name:
Primary DNS Server:
Secondary DNS Server:
MTU: Auto
Mac Address Clone:
Enabled
Enable NAT:
⌵
Advanced Settings ...
⌵
⌵
<< MAC Address
34