Troubleshooting - AEG ProCombi BS9304001 User Manual

44 www.aeg.com
The side lamp
1. Remove the left shelf support to get
access to the lamp.
2. Use a Torx 20 screwdriver to remove
the cover.
3. Remove and clean the metal frame
and the seal.
4. Replace the lamp with a suitable 300
°C heat-resistant lamp.
5. Install the metal frame and the seal.
Tighten the screws.
6. Install the left shelf support.

13. TROUBLESHOOTING

13.1 What to do if...
Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The display shows F111.
WARNING!
Refer to Safety chapters.
Possible cause
The oven is deactivated.
The clock is not set.
The necessary settings are
not set.
The automatic switch-off is
activated.
The Child Lock is on.
The door is not closed cor-
rectly.
The fuse is released.
The lamp is defective.
The plug of the core tem-
perature sensor is not cor-
rectly installed into the sock-
et.
Remedy
Activate the oven.
Set the clock.
Make sure that the settings
are correct.
Refer to "Automatic switch-
off".
Refer to "Using the Child
Lock".
Fully close the door.
Make sure that the fuse is
the cause of the malfunction.
If the fuse releases again
and again, contact a quali-
fied electrician.
Replace the lamp.
Put the plug of the core tem-
perature sensor as far as
possible into the socket.