Place Call Using Name, Number Or Video Address - Cisco TelePresence SX10 User Manual

12
Place Call

Place Call Using Name, Number or Video Address

Make sure Call (the leftmost icon along the bottom of the
screen) is selected and press OK on the remote control
or press the green Call button on the remote control.
To enter numbers just press the corresponding keys on
the remote control.
Then press the green Call button to place the call.
Use the up Cursor key to select the Search or Dial field
at the top of the menu. Press OK.
To use the virtual keyboard, move down to and about the
keyboard and select characters. Press OK to select a
character.
Press the red End Call button on the remote control, or
use the Cursor keys to select End and then press OK to
terminate the call.
About Placing Calls
You may call someone who is not
listed in your list of contacts by
keying in their name, address or
number using the virtual keyboard.
Anyone you have previously called
will appear in the Recents list and
you may then add any of them
to your list of Favorites. This is
described in the section Contacts.
Call Using Video Address
The procedure when using an IP
type video address to call someone
is similar. Just key in the address
and use (the asterisk button in
*
the lower left corner on the remote
control) as separator. The system will
interpret this as a valid IP address
separator so that the video address
appears as correctly entered.
D1509708 User Guide
Cisco TelePresence TRC 6
Produced: July 2016 for CE 8. 2
All contents © 2010–2016
Cisco Systems, Inc. All rights reserved.