Operating Controls - Sharp EL-1750PIII Operation Manual

OPERATING CONTROLS

ON
POWER SWITCH; PRINT / ITEM
OFF • P P•IC
COUNT MODE SELECTOR:
"OFF": Power OFF
"•": Power ON. Set to the non print mode.
"P": Power ON. Set to the print mode.
"P•IC": Power ON. Set to the print and item count
mode.
1) For addition or subtraction, each time
is pressed, 1 is added to the item
counter, and each time
is subtracted.
• The count is printed when the calcu-
lated result is obtained.
• Pressing of
counter.
2) When the grand total/rate setting mode
selector is in the ON position (GT), the
counter will count the number of times
that the calculation results have been
stored in the grand total memory. To print
and clear the count, press the
3) The memory item counter will count the
number of times that the
been pressed in the addition.
is pressed, 1
, clears the
key.
key has
Note: • Each time the
the subtraction, 1 will be subtracted
from the count.
• The count is printed when the
memory is recalled.
• Pressing of the
counter.
Note: The counter has a maximum capacity of 3
digits (up to ±999). If the count exceeds the
maximum, the counter will recount from zero.
ROUNDING SELECTOR:
Example: Set Decimal Selector to 2.
÷
4 9 = 0.444 ... , 5
4 9
0.45
5/4 0.44
0.44
Note: The decimal point floats during successive
calculation by the use of
If the decimal selector is set to "F" then the answer is
always rounded down ( ).
4
key is used in
key clears the
÷
9 = 0.555 ...
5 9
0.56
0.56
0.55
or .