Zanussi ZCG61236 User Manual page 25

Assemble the burner in a revers sequence.
Replace the gas type sticker near the gas
supply ramp with the one related to the new gas
type.
Adjusting the minimum gas level on the
oven burner
1. Disconnect the appliance from the
electricity.
2. Remove the knob for the oven functions. If
there is no access to the bypass screw
dismount the control panel before
adjustment start.
3. With a thin and flat screwdriver adjust the
bypass screw A.
The model determines the position of the
bypass screw A.
A
Changing from natural gas to liquid gas
1. Fully tighten the bypass screw.
2. Put the knob back.
3. Connect the appliance to the electricity.
Changing from liquid gas to natural gas
www.zanussi.com
1. Unscrew approximately one turn the bypass
screw position A.
2. Put the knob for the oven functions back.
3. Connect the appliance to the electricity.
WARNING!
Put the mains plug into the
mains socket only if all parts are
back into their initial position.
There is a risk of injury.
4. Light the burner.
Refer to "Oven - Daily use" chapter.
5. Turn the knob for the oven functions on the
minimum position.
6. Remove the knob for the oven functions
again.
7. Screw on slowly the bypass screw till the
flame becomes minimum and stable.
8. Put the knob for the oven functions back.
9. Set the maximum gas flow position on the
knob for the oven functions and let the oven
heat for at least 10 minutes.
10. Quickly turn the knob for the oven functions
from maximum to the minimum gas flow
position.
Control the flame. Make sure the flame does not
go out when you turn the knob to the minimum
gas flow position. There must be a small regular
flame on the oven burner crown. If the flame
goes out adjust the oven burner again.
Gas grill injector replacement
1. Release the screws which keep the grill
burner in position A.
2. Release the burner injector with a 7 mm
socket spanner and replace it with a right
one.
A
25