Manual Update Via A Usb Flash Drive (When The Update Via A Network Has Failed) - Sony SRS-ZR7 Help Manual

Help Guide
Personal Audio System
SRS-ZR7

Manual update via a USB flash drive (when the update via a network has failed)

If the (power) indicator flashes in red and the UPDATE indicator flashes in orange, the software update has failed. In this case,
the speaker will not respond to any operation and no function can be used, except the
Follow the procedure below to check the speaker's condition, then complete the software update with an appropriate method.
Press the (power)/
1
speaker.
Wait for about three minutes (or until a network connection is established), then check the condition
2
of the UPDATE indicator and
When the UPDATE button lights up in orange: The update is not complete, though the speaker can be used
normally. Turn the speaker off again, then refer to the following to complete the software update using a USB flash drive.
Update method 3: Manual update via a USB flash drive
When the UPDATE indicator flashes in orange and the
the situation before turning the speaker on again): The update has failed and the speaker cannot be used.
Proceed to the next step to update using a USB flash drive.
The update procedure is different from "Update Method 3" and the following steps are required. In this case, the update
cannot be performed via a network.
If the UPDATE indicator flashes in orange and the
3
procedure below to update.
1.
Download the update file from the website below, then store it in a USB flash drive.
For customers in Europe:
http://www.sony.eu/support
For customers in the USA:
http://esupport.sony.com/US
For customers in Canada:
http://esupport.sony.com/CA/
For customers in other countries/regions:
http://www.sony-asia.com/section/support
2. Turn the speaker off again.
After turning off the speaker, complete following steps until turning on the power again within three minutes.
3. Connect the USB flash drive to the USB-A port (
PAIRING button to turn off the speaker, and then press it to turn on the
(power) indicator.
(power)/
(power) indicator flashes in red (the same as
(power) indicator flashes in red, follow the
A) on the rear of the speaker.
PAIRING button operation.
220