Table of Contents
Advertisement
5. Insert the notched end
and pivot the memory module until it snaps into position. Ensure that the memory module is secured
in the slot and does not move easily.
Figure 22. Installing a memory module
6. Install the memory module shield. See "Replacing the memory module shield" on page 55.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 59.
Replacing the storage drive
Attention: Do not open your computer or attempt any repair before reading and understanding the "Read
this first: Important safety information" on page iii .
To replace the storage drive, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Remove the back cover. See "Removing the back cover" on page 54.
3. Locate the storage drive. See "Computer components" on page 5 .
4. Press the handle
1
to remove them from the chassis.
Figure 23. Removing the storage drive bracket and the storage drive
5. Disconnect the storage drive cable from the storage drive.
2
of the new memory module into the slot
as shown, and then pivot the storage drive bracket and the storage drive as shown
1
. Press the memory module firmly
.
Chapter 7
Installing or replacing hardware
57
Advertisement
Table of Contents
