Unleaded solder
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size.)
: LEAD FREE MARK
Unleaded solder has the following characteristics.
• Unleaded solder melts at a temperature about 40°C higher than
ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350°C.
Caution: The printed pattern (copper foil) may peel away if the
heated tip is applied for too long, so be careful!
• Strong viscosity
Unleaded solder is more viscous (sticky, less prone to flow) than
ordinary solder so use caution not to let solder bridges occur such
as on IC pins, etc.
• Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.
TABLE OF CONTENTS
2. GENERAL ···································································
3. DISASSEMBLY ··························································
3-6. Tray ··············································································· 9
3-7. CDR Board ································································· 10
3-11. Cam (CH) ···································································· 12
3-12. MAIN Board ······························································· 12
3-17. Tray (Sub) ··································································· 15
Slider (Shutter) ···························································· 17
3-24. BD Board ···································································· 19
···································································· 21
CD SECTION ····························································· 24
······································································ 55
6-4. Printed Wiring Board
6-5. Schematic Diagram
······················································ 54
7-1. Case Section ·································································· 90
7-8. CDM65-RBD1 ······························································ 97
RCD-W50C
4
5
6
······························· 24
······································· 98
3