Table of Contents
Advertisement
Enable: Enable a line; if some lines are not used, disable them (Pause Function) to avoid
unnecessary waiting when an incoming call is diverting to this line.
Hotline Functions
FXS port: When the user picks up the phone, the gateway automatically dials your assigned
hotline number. When in hotline mode, other lines cannot be used.
FXO port: When receiving a call from an outside line, the gateway will divert the call to the
assigned hotline number.
Hot Line No.: Enter the hot line number for an automatic dialing function.
Warm Line: When the warm line function is in use, user can dial a number. Otherwise the
system will divert incoming calls from an outside line to the Hot Line Number after a set wait
time.
Example:
1. The assigned hotline for DVG-7022S L1 is 701 and the Warm Line(Hot Line Delay) is 5 seconds.
If no extension number is dialed within 5 seconds, the call will be automatically diverted to the
assigned hotline (ext 701). The system allows users to record a voice prompt (e.g. "please enter
an extension number or wait for the operator to connect you") to use in this situation.
2. The assigned hotline for DVG-7022S L2 is 702 and the wait time is 0 second. When L2 receives
a call from an outside line, it will be automatically diverted to extension 702.
Dial-out Prefix: It is the number dialed automatically by the system when the FXO interface
diverts a call to the PSTN by VoIP.
FXO Line Default Dial-Out: To set the dial-out number when this FXO line is indicated.
Example:
If PBX extension needs to dial "0" to make a PSTN call, and the FXO are connected to PBX extension.
In this case, the Dial-out prefix should be set to "0". If the PBX requires some delay time before
capturing a line, then the trunk prefix should be set as "0," so that after dialing a 0, it will pause for 1
second before dialing the destination number. Each comma represents a 1 second delay. If more
delay time is required, simply add more commas. Please note that if a Dial-out prefix is set, the line
won't be able to dial to any PBX extension line (FXS interface does not have a trunk prefix function).
Please refer to Section 6 if required to dial to a PBX extension line and PSTN concurrently.
FXS Group: Select group hunting when there is an incoming call, the gateway will
automatically assign an unassigned call according to Hunting Priority. If Line 2 does not
want to be set as an assigned line to receive any inbound calls, the function can be disabled.
Users can also use the Up or Down key to adjust hunting priority.
Enable FAX: Enable this line to detect if there is a FAX tone to transfer the Codec.
Advertisement
Table of Contents
