Satellite Setting - LG HR922S Owner's Manual

,
Note
y If a connected HDMI device does not accept
the audio output of the unit, the HDMI
device's audio sound may be distorted or
may not output.
y When you use HDMI connection, you can
change the resolution for the HDMI output.
(Refer to "Resolution Setting" on page 18.)
y Select the type of video output from the
HDMI OUT jack using [HDMI Color Setting]
option on the [Setup] menu (see page 33).
y Changing the resolution when the
connection has already been established
may result in malfunctions. To solve the
problem, turn off the player and then turn it
on again.
y When the HDMI connection with HDCP is
not verified, TV screen is changed to black
screen. In this case, check the the HDMI
connection, or disconnect the HDMI cable.
y If there is noise or lines on the screen, please
check the HDMI cable (length is generally
limited to 4.5m).
Additional Information for HDMI
y When you connect a HDMI or DVI compatible
device make sure of the following:
- Try switching off the HDMI/DVI device and
this player. Next, switch on the HDMI/DVI
device and leave it for around 30 seconds,
then switch on this player.
- The connected device's video input is set
correctly for this unit.
- The connected device is compatible with
720x576p, 1280x720p, 1920x1080i or
1920x1080p video input.
y Not all HDCP-compatible HDMI or DVI devices
will work with this player.
- The picture will not be displayed properly
with non-HDCP device.
- This player does not playback and TV screen
is changed to black screen.

Satellite Setting

Once you have completed setting the digital
receiver to your individual preferences, you can
proceed, if necessary, to adjust the unit settings
to your antenna. The menu [Satellite Setting]
contains the satellites that have been selected in
the installation assistant. If the installation assistant
was interrupted, the satellite position [Astra19.2E]
is pre-programmed. Should you wish to receive
other satellites, or if you are using a different type
of LNB, you can adjust your digital receiver to the
appropriate data as follows:.
Antenna Setting
1. Select [Satellite Setting] option in the [DTV]
menu, then press ENTER (b).
,
Note
If the [DTV Lock] option is set to [Lock], this
function is available when you enter the
password correctly. (see page 30 .)
2. The [Satellite Setting] menu appear on the
screen. Use W/S to select the [Antenna
Setting] and then press ENTER (b).
3. Use A/D to select a desired particular
satellite.
15
Connecting
2