Vmesystem Enclosure; System Console Terminal; Overview Of Start-Up Procedures; Table 1-3. Start-Up Overview - Motorola MVME2401-1 Installation And Use Manual

Preparing and Installing the MVME2400-Series Module
1

VMEsystem Enclosure

System Console Terminal

Overview of Start-Up Procedures

What you need to do ...
Unpack the hardware.
Set jumpers on the MVME240x
module.
Prepare the PMCs.
1-4
The MVME240x board supports both front panel I/O and rear panel P2 I/O
through either PMC slot 1 or PMC slot 2. 64 pins of I/O from slot 1 and 46
pins of I/O from slot 2 are routed directly to P2.
Your MVME240x board must be installed in a VMEsystem chassis with
both P1 and P2 backplane connections. It requires a single slot, except
when PMCspan carrier boards are used. Allow one extra slot for each
PMCspan.
In normal operation, connection of a debug console terminal is required
only if you intend to use the MVME240x's debug firmware, PPCBug,
interactively. An RJ45 connector is provided on the front panel of the
MVME240x for this purpose.
The following table lists the things you will need to do before you can use
this board, and tells where to find the information you need to perform
each step. Be sure to read this entire chapter and read all Caution and
Warning notes before beginning.

Table 1-3. Start-Up Overview

Refer to ...
Unpacking the MVME240x Hardware
Preparing the MVME240x Hardware
MVME240x
PMCs
For additional information on PMCs, refer to
the PMC manuals provided with these cards.
Computer Group Literature Center Web Site
On page ...
1-7
1-7
1-7
1-13