Zanussi ZOU 365 User Manual page 31

To perform this operation correctly, proceed as
follows:
a) the decorated internal pane with a frame on the 4 sides
must be reassembled so that the screen-printing is facing
outwards. The side of the pane of glass is correct if you
do not feel any roughness near the screen printing when
you pass your fingers over the surface.
The internal pane of glass must be put back into the right seats
as shown in Fig. 8.
After the panes of glass have been reassembled in the oven
door, perform the procedure described in point 8. in reverse
to ensure they are locked.
How to clean the oven door seal
A rubber seal around the oven opening guarantees correct
operation.
Check the condition of this seal periodically.
If it has to be cleaned, do not use abrasive
objects or substances. If you notice that the
seal is damaged, contact your local service
centre and do not use the oven until it has been
repaired.
Oven Shelf Support Rails
The shelf support rails on the left and right hand sides
of the oven can be removed for cleaning the side walls.
Removing the shelf support rails
First pull the front of the rail away from the oven wall
and then unhitch at the back (Fig. 9, Fig. 10).
Fitting the shelf support rails
To install, first reattach the rails at the back, then put
them into position at the front and press them into place
(Fig. 11).
To clean the shelf support rails, soak in warm soapy
water and remove stubborn marks with a well wetted
soap impregnated pad.
Rinse well and dry with a soft cloth.
Fig. 8
Fig. 9
Fig. 10
Fig. 11
31