Fiche Technique - Fantom Falcon FC251 Owner's Manual

COMPOSANTS DE VOTRE ASPIRATEUR CYCLONIQUE
SANS SAC
1. Interrupteur d'alimentation
2. Moteur
3. Tube télescopique
4. Cordon d'alimentation du moteur
5. Commande d'aspiration variable
6. Prise pour l'alimentation du moteur
7. Lumière
8. Filtre après le moteur
9. Bouton d'alimentation électrique
10. Poignée de l'aspirateur
11. Bouton de rembobinage du cordon

Fiche technique

Appareil principal: Tension: 120 V., 60 Hz.
Alimentation: 10,5 A
Moteur du balai: Tension: 120 V., 60 Hz.
Alimentation: 12 A
22
12. Poignée du contenant à déchets
13. Plateau pour les accessoires
14. Tuyau flexible
15. Filtre HEPA
16. Brosse de nettoyage du filtre HEPA
17. Cordon de raccordement
18. Prise du cordon de raccordement
19. Suceur plat
20. Brosse
21. Brosse d'époussetage
(s'enclenche sur la brosse ordinaire)
22. Brosse à plancher/tapis
11
FOR REPLACEMENT FILTER INFORMATION
or for Technical Support
for Model FC251
Call FANTOM Customer Service: 1 - 800 – 275-9251
Monday to Friday 8:30 A.M. - 5:00 P.M. Eastern Standard Time
visit our website: www.fantom.com
Please Note:
The HEPA Dust Cup Filter is washable. We recommend that this be done
once a month or when suction appears reduced. It should, however, be
replaced every six (6) months to ensure peak performance of your vacuum. It
is important that when you wash the HEPA dust cup filter, you allow it to dry
COMPLETELY before using it again. We recommend 24 hours to air dry. DO
NOT DRY IN DRYER.
The Post Motor Filter is washable. It should however be replaced every three
(3) months to ensure peak performance of your vacuum.
Important:
Make sure that ALL filters are completely dry before re-installing back in the
hand vacuum.
All filters should be checked regularly for signs of damage, preferable after
each cleaning task. The filters must be replaced immediately if they become
damaged.
Always disconnect the vacuum from the electrical outlet when checking the
filters.
Important
:
This vacuum cleaner is equipped with a motor protective thermostat. If for
some reason your vacuum overheats, the thermostat will automatically turn
the unit off. Should this occur, unplug the vacuum from the wall outlet and turn
off the switch. Empty the dust cup, "TapClean" the dust cup filter and check
for blockages in hose and suction inlet. Allow the unit to cool for a minimum of
45 minimum prior to restarting the unit. To restart, re-plug the vacuum into the
wall socket and turn the switch back on.
or
8