Electronic Parking Brake Reset; Steering Angle Calibration; Abs Bleeding; Tire Pressure Monitor System Reset - Launch X-431 PROS V4.0 User Manual

Hide thumbs Also See for X-431 PROS V4.0:

Table of Contents

LAUNCH

6.2 Electronic Parking Brake Reset

This function enables you to reset the brake pad after replacing the brake pad.

It needs to be performed in the following cases:

1. The brake pad and brake pad wear sensor are replaced.

2. The brake pad indicator lamp is on.

3. The brake pad sensor circuit is short, which is recovered.

4. The servo motor is replaced.

This function enables you to reset the steering angle, after replacing the steering

angle position sensor, replacing steering mechanical parts (such as steering

gearbox, steering column, end tie rod, steering knuckle), performing four-wheel

alignment, or recovering car body.

This function allows you to perform various bi-directional tests to check the

operating conditions of Anti-lock Braking System (ABS).

It needs to be performed in the following cases:

1. When the ABS contains air.

2. When the ABS computer, ABS pump, brake master cylinder, brake cylinder,

brake line, or brake fluid is replaced.

This function enables you to quickly look up the tire sensor IDs from the vehicle's

ECU, reset tire pressure and turn off the tire pressure MIL.

It needs to be performed in the following cases:

Tire pressure is too low, tire leaks, tire pressure monitoring device is replaced or

installed, tire is replaced, tire pressure sensor is damaged, and tire is replaced

for the car with tire pressure monitoring function.

This function enables you to perform tooth learning for the car, to turn off the

MIL.

X-431 PROS V4.0 User Manual

Table of Contents