Summary of Contents for Fanimation Extraordinaire OF110 Series
Page 1
™ The Extraordinaire Orbital Ceiling Fan WARNING: Support Directly From Building Structure Net Weight 14.5 lbs. or 6.59 kg. Model No. OF110** Series OWNER’S MANUAL READ AND SAVE THESE INSTRUCTIONS...
Fanimation. 7. Fanimation reserves the right to modify or discontinue any product at any time and may substitute any part under this warranty. 8. Under no circumstances may a fan be returned without prior authorization from Fanimation. The receipt of purchase must ac- company authorized returns and must be sent freight prepaid to Fanimation.
Fanimation. Substitution of parts or accessories not designated for use with this product by Fanimation could result in personal injury or property damage. Contact your retail store for missing or damaged parts.
Electrical and Structural Requirements Your new ceiling fan will require a grounded electrical supply line of 120 volts AC, 60 Hz, 15 amp circuit. The outlet box must be securely anchored and capable of withstanding a load of at least 50 lbs. Figure 1 depicts different structural confi...
How to Assemble Your Ceiling Fan (cont’d) 5. Slide the motor coupling cover down until it touches the top of the motor and assemble ceiling canopy as shown. (Figure 3) 6. Before installing fan, measure up approximately 6-9 inches above top of downrod. Cut off excess wire and strip back insulation ½˝...
Page 6
How to Hang Your Ceiling Fan (cont’d) CAUTION To Reduce the Risk of Personal Injury, this Product Must be Secured as Described in the Manual. 1. Attaching Ceiling Support Cable (Figure 2): Drill ¼˝ pilot hole through one of the four corners of the junction box, into the ceiling joist or structural member.
How to Wire Your Ceiling Fan – Rotary Switch If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a licensed electrician. ▲WARNING To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring.
How to Wire Your Ceiling Fan – CW110 Wall Control (cont’d) • Attach wall control unit to outlet box using the two 6-32 screws provided. • Attach wall plate to the switch control front using the two small screws provided. ▲WARNING Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire...
Operating Instructions - CW110 Wall Control 1. Restore electrical power to the outlet box by turning the electricity on at the main fuse box. 2. NOTE: Set the rotary switch to High speed before using the wall control. The operating sequence is as follows: •...
Parts List Model #OF110** Ref. # Description Hanger Bracket with mounting hardware Downrod with Clevis Pin, Hairpin Clip & Rubber Sleeve Ceiling Canopy Motor Coupling Cover Fan Motor Assembly Wall Control Hardware Bag Containing: 7/16˝ Wrench (2) ⅜˝ x 5˝ Lag Bolt with Flat Washer 1½˝...
1 (ref) NOTE: The illustration shown is not to scale or its actual confi guration may vary. Wires partially removed for clarity. The Extraordinaire Exploded-View Figure 1 ™...