Advertisement
Manual # 016-0230-001
C
H A P T E R
C
& W
H
O N T R O L L E R
I R I N G
A R N E S S
Tee into machine's hydraulic valve coil connectors with boom sense
connectors on Autoboom cable (Left tilt Up/Down and Right tilt Up/
Down).
When the Autoboom system is fully installed and turned on, tapping down
on the prop handle should enable Autoboom. Tapping up on the prop
handle should disable Autoboom.
Use the diagrams on the following pages to install the wiring harness.
Be sure to allow enough slack in the harness to allow for racking the
booms.
Connect power leads to battery. Do not reverse the power leads. Doing so
will cause severe damage to equipment. Always check that the power leads
are connected to the correct polarity as marked and ensure that the power
cable is the last cable to be connected.
2 5
Advertisement
