Introduction; Maintenance Schedule; Maintenance - Honeywell WP230A-M Service Data

Table of Contents

Advertisement

1 . Check the oil level (and oil pressure on 2
and larger),
3. Check the tank and
bserve compressor operation to ascertain that the
pump does build up to cut-out pressure and does
shut off.
2. Check intake filters,
uincy units of 1/4 to 3/4
P units and larger are pressure lubricated.
dipstick is provided on all units for checking
level. To check the oil level, stop the pump, remove the
dipstick, wipe it off, and replace it. Then remove it again
and check the level of oil, If oil is needed; add it through
the dipstick hole, ny good grade nondetergent oil is
satisfactory. Consult Table I for correct oil viscosity.
V pressure .
are splash lubricated
A
the oil
depe
iring
3. Check tension and condition of the belts.
4, Check safety relief valves,
6. Check drier operation (
Every Year
1. Change the intake filters.
2. Change compressed air filters,
N
: If the compressor
dirty or dusty atmosphere,
to be changed more frequently . The three
month checks will indicate a need for more
frequent replacement.
is installed in an extremely
the filters may need

Advertisement

Table of Contents
loading

Subscribe to Our Youtube Channel

This manual is also suitable for:

Wp240a-gWp250a-f

Table of Contents